Court Setup Guide

From box to game-ready in minutes. Here's everything you need to know.

Download Printable Guide

Step-by-Step Setup

1

Choose Your Surface

Find a clean, flat surface large enough to accommodate your court plus at least 3 ft of clearance on all sides. For a 21 ft x 45 ft court, that means a minimum space of 27 ft x 51 ft.

2

Unbox & Unwrap

Your court arrives in a crate with 4 rolls. Cut the straps and lift off the lid, then take out each roll with a helper. Remove the wrapping from every roll before you unroll, and keep it to reuse when you re-roll and store the court.

3

Prepare the Surface

Make sure you are working on a hard, solid surface. Sweep and clean the area thoroughly. Remove all debris, dirt, or moisture before unrolling.

4

Mark Your Layout

Using a measuring tape, mark your court boundaries on the surface before unrolling. Start from the center of your space and work outward to ensure your court is evenly positioned.

5

Unroll the Court

Your court arrives in 4 sections. Starting at one baseline, carefully unroll each section toward the opposite baseline. Keep each strip tight and flat as you go, with one person guiding each end for best results.

6

Secure the Court

Once your court is unrolled and positioned, choose your preferred installation method below. For temporary setups or events, always use tape to secure the edges - never use glue or adhesive on a surface you do not own.

7

Set Up the Net

Place your net posts at the center of each sideline. Attach the net and adjust to the proper height - 36 inches at the posts and 34 inches at the center.

8

Store Your Court

After play, clean the surface of any debris before rolling. Roll each section loosely and evenly to avoid creasing or warping. Store in a cool, dry place away from direct sunlight and extreme temperatures. Avoid storing heavy objects on top of rolled sections, as this can permanently crease the material.

Watch the Setup Guide

Installation

The Basics

  • •Use double-sided court tape along all edges
  • •Press firmly with a roller for full adhesion
  • •Smooth out air bubbles from center outward
  • •To remove: peel tape slowly at a low angle
  • •Do not use duct tape - it leaves residue
  • •Contact our team for information on permanent setup

Pro Tips

  • •On hot days, mist the surface lightly with water to cool it before play.
  • •Do not play on a wet court - dry the surface fully before use.
  • •Store rolled, never folded. Keep in a dry, cool space between uses.
  • •Clean with mild soap and water after each use to extend court life.

Compatible Surfaces

DrivewayParking LotTennis CourtGym FloorWarehouse FloorRooftopEvent Center Floor